Life Fitness Treadmill 9100 Series User Manual

Life Fitness Model 9100 Series Treadmill  
How To…INSTALL WAX NOZZLE BRACE  
Tools Required: Hex Key wrench set, combination wrench set.  
GK26-00002-0060  
Step 1  
Turn the ON/OFF switch to the OFF position and disconnect the line-cord from the wall receptacle.  
Step 2  
Remove the 4 SCREWS securing the MOTOR SHROUD. Remove MOTOR SHROUD and set aside.  
Step 3  
Remove the tension from the STRIDING BELT by turning each ROLLER TENSION BOLT eight rotations in a  
counter clockwise direction.  
Step 4  
Remove the 4 SCREWS and WASHERS securing the DECK. Remove the DECK.  
Step 5  
Remove and clean the WAX NOZZLE. Set it aside to be re-installed later.  
Step 6 ( Figure 1)  
Shift STRIDING BELT to one side to gain access to the WAX NOZZLE BRACKET. Using the NOZZLE BRACE as  
a gauge, hold it flush against the bottom of the WAX NOZZLE BRACKET and position it against the angle of the  
BRACKET TAB. This will determine the amount of bend required to change the angle of the BRACKET TAB so that  
it matches the angle on the NOZZLE BRACE.  
Step 7 (Figure 2)  
Tinnerman  
Clips  
Position a 9/16 box end wrench over the cylinder portion  
of the BRACKET TAB and gently bend to the determined  
amount from Step 6.  
Step 8 ( Figure 1)  
Insert NOZZLE BRACE to ensure that the WAX NOZZLE  
BRACKET is bent to the proper angle.(Repeat steps 6  
and 7 as required.)  
Step 9 ( Figure 1)  
Nozzle  
Center the NOZZLE BRACE against the BRACKET TAB  
and secure the NOZZLE BRACE to the WAX NOZZLE  
BRACKET with 2 TINNERMAN CLIPS. The TINNERMAN  
CLIPS should be flush with both the WAX NOZZLE  
BRACKET and NOZZLE BRACE.  
Brace  
Wax Nozzle  
Bracket  
Figure 1  
Step 10  
Re-install cleaned WAX NOZZLE.  
Step 11  
Install the deck and secure with mounting bolts.  
9/16 Box  
Wrench  
Step 12  
Center STRIDING BELT, then tension by turning each REAR  
ROLLER TENSION BOLT eight rotations in a clockwise  
direction.  
Direction  
Of Bend  
Bracket Tab  
Step 13  
Re-install the MOTOR SHROUD and secure with 4 screws.  
Step 14  
Track or tension STRIDING BELT as necessary. Refer to  
“How To“ in a Service or Operation manual for proper  
procedure.  
Wax Nozzle  
Bracket  
Figure 2  
MO51-00K26-A262  
 

LG Electronics Marine Radio RJP 110F User Manual
Link electronic Network Router 862 XL804HD 3A User Manual
Lochinvar Water Heater 000 300 User Manual
Loewe Flat Panel Television Aventos 3772 Z User Manual
Lowrance electronic Marine Instruments 000 0106 72 User Manual
Mackie Musical Instrument U420 User Manual
Magic Chef Refrigerator MCBR415S User Manual
Maytag Clothes Dryer MD 24 User Manual
Maytag Clothes Dryer MGD3000B User Manual
Metra Electronics Car Amplifier 70 2054 User Manual