Lennox Hearth Outdoor Fireplace DPSS36 User Manual

HEARTH PRODUCTS  
KITS AND ACCESSORIES  
750,213M  
05/2006  
DRAIN PAN  
INSTALLATION INSTRUCTIONS FOR LENNOX OUTDOOR FIREPLACE  
DRAIN PAN DPSS36 (P/N H4651) & DPSS42 (P/N H4652)  
GENERAL INFORMATION  
Although the fireplace is designed to operate safely outdoors, rain  
and other sources that may enter the hearth area, condensation and  
unusual conditions, will cause water to collect inside the fireplace  
bottom.  
Threaded  
Reducer  
³⁄₄” x ¹⁄₂”  
(PVC)  
Threaded  
Elbow ³⁄₄”  
@ 90°  
(PVC)  
To prevent water collection, the builder must provide a means to  
drain water from under the fireplace by building or installing a  
water collector of the builders choice, before positioning the  
fireplace on its location.  
Drain Connector Detail  
Special care must be taken when the fireplace is installed against an  
exterior wall. The enclosure surrounding the fireplace on the sides  
and back must be treated as an exterior wall.  
Lennox does provide this optional drain pan to assist weatherproof-  
ing the fireplace. H4651 DPSS36 Drain Pan for E36ODG, H4652  
DPSS42 Drain Pan for E42ODG.  
45”  
INSTALLATION INSTRUCTIONS  
When Planning for the installation of the fireplace, the framing  
height must be increased from 46-1/2 inches to 47-1/4 inches,  
when installing the drain pan. An additional space below the  
fireplace will also be required to plumb a drain line.  
Seal (4) Places  
Drain Pan  
Model  
Step 1. Seal all joints, gaps and corners around the bottom of the  
drain pan before positioning the fireplace on its location (Figure 1 ).  
Cat. No.  
H4651  
Description  
Drain Pan (36)  
Drain Pan (42)  
DPSS36  
DPSS42  
H4652  
Step 2. On the exposed drain hole, install a PVC threaded  
coupling reducer, 3/4" x 1/2" going from the top of the pan, down  
through the hole. Apply a silicone-based sealant around the base  
and threads before installation.  
Drain Pan  
Figure 1  
Step 3. Holding the reducer coupling with a wrench, thread a 3/4", 90  
degree, PVC elbow to the reducer until it is tight to the metal.  
Note: To assure proper drainage, the fireplace must be installed on a  
leveled surface.  
Step 4. Add additional piping to route the drain to an appropriate  
location.  
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.  
Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products.  
Consult your local distributor for fireplace code information.  
LHP  
Printed in U.S.A. © 2006 by LHP  
1110 West Taft Avenue  
P/N 750,213M REV. N/C 05/2006  
Orange, CA 92865  
 

La Crosse Technology Thermostat WS 9029U User Manual
Lasko Electric Heater 5309 User Manual
Leviton Network Card 5F100 xxx User Manual
LG Electronics Clothes Dryer DLE2140W User Manual
LG Electronics Microwave Oven LMV1635SB User Manual
Lincoln Welder LN 742 User Manual
Linn MP3 Player Klimax DS User Manual
Mace Security Camera CAM 53CIR User Manual
Magnadyne Cassette Player LS6000 User Manual
Makita Cordless Saw LS0714 User Manual