La Crosse Technology Clock 308 1410gr User Manual

Model: 308-1410gr  
Instruction Manual  
DC: 072915  
WIRELESS THERMOMETER  
FRONT  
VIEW  
SENSOR  
TX-141-Bv2  
LED  
TX  
Sensor  
Sensor Battery  
Battery Cover  
Compartment  
2 “AA”  
Buttons  
BACK VIEW  
Battery  
Compartment  
Battery  
Cover  
2 “AA”  
GET STARTED  
Step 1: Insert 2 new AA batteries (not included) into the station.  
Observe the correct polarity.  
Step 2: Insert 2 new AA batteries (not included) into the TX141-BV2 sensor. Observe the  
correct polarity. The red LED will flash when transmitting.  
Step 3: After 15 minutes place the sensor outside in a shaded location.  
Note: If the outdoor temperature is not displayed after 3 minutes, hold the MIN/MAX/+  
button for 3 seconds to search for the sensor. Press the TX button on the sensor to send a  
signal.  
Page | 1  
 
SPECIFICATIONS  
+32°F to +122°F (0°C to 50°C)  
Indoor:  
Temperature Range:  
Interval:  
About every 30 seconds  
Outdoor:  
Temperature Range:  
Alkaline Batteries:  
Lithium Batteries:  
-40°F to 140°F (-40°C to 60°C)  
-20°F to 140°F (-28.8°C to 60°C)  
-40°F to 140°F (-40°C to 60°C)  
Temperatures below - 20°F (-28.8°C)  
require Lithium batteries in the outdoor  
sensor.  
NOTE:  
Over 300 ft. (91 meters)  
RF 433MHz (open air)  
Distance:  
Interval:  
About every 50 seconds  
Power:  
Wireless Thermometer  
TX141-BV2 Sensor:  
Battery Life:  
2-AA, IEC, LR6 batteries (not included)  
2-AA, IEC, LR6 batteries (not included)  
Battery life is over 24 months when  
using reputable battery brands for both  
Alkaline and Lithium batteries  
Wireless Thermometer  
Battery life is over 24 months when  
using reputable battery brands for both  
Alkaline and Lithium batteries  
TX141-BV2 Sensor:  
Dimensions:  
3”L x 1.36”W x 4.17”H  
(76 x 34 x 106 mm)  
1.57" x 0.79" x 5.12"  
(40 x 20 x 130mm)  
Wireless Thermometer:  
TX141-BV2 Sensor:  
CARE AND MAINTENANCE  
Do not mix old and new batteries  
Do not mix Alkaline, Standard, Lithium or Rechargeable Batteries  
Always purchase the correct size and grade of battery most suitable for the  
intended use.  
Replace all batteries of a set at the same time.  
Clean the battery contacts and also those of the device prior to battery  
installation.  
Ensure the batteries are installed correctly with regard to polarity (+and -).  
Remove batteries from equipment with is not to be used for an extended  
period of time.  
Remove used batteries promptly.  
Page | 3  
 
WARRANTY AND SUPPORT INFORMATION  
La Crosse Technology, Ltd. provides a 1-year limited time warranty (from date of purchase) on  
this product relating to manufacturing defects in materials & workmanship.  
View full warranty details online at:  
For warranty work, technical support or other information contact:  
La Crosse Technology, Ltd  
2830 South 26th St  
La Crosse, WI 54601  
Contact Support:  
Online Product Support:  
1-608-782-1610  
Product Registration:  
Protected under U.S. Patents:  
5,978,738 | 6,076,044 | RE43903  
FCC STATEMENT  
This equipment has been tested and found to comply with the limits for a Class B digital  
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide  
reasonable protection against harmful interference in a residential installation. This  
equipment generates, uses and can radiate radio frequency energy and, if not installed and  
used in accordance with the instructions, may cause harmful interference to radio  
communications. However, there is no guarantee that interference will not occur in a  
particular installation. If this equipment does cause harmful interference to radio or  
television reception, which can be determined by turning the equipment off and on, the user  
is encouraged to try to correct the interference by one or more of the following measures:  
Reorient or relocate the receiving antenna.  
Increase the separation between the equipment and receiver.  
Connect the equipment into an outlet on a circuit different from that to which the  
receiver is connected.  
Consult the dealer or an experienced radio/TV technician for help.  
This device must not be co-located or operating in conjunction with any other antenna or  
transmitter.  
Operation is subject to the following two conditions:  
(1) this device may not cause harmful interference, and  
(2) this device must accept any interference received, including interference that  
may cause undesired operation.  
Caution!  
The manufacturer is not responsible for any radio or TV interference caused by  
unauthorized modifications to this equipment. Such modifications could void the user  
authority to operate the equipment.  
All rights reserved. This manual may not be reproduced in any form, even in part, or  
duplicated or processed using electronic, mechanical or chemical process without the  
written permission of the publisher.  
This booklet may contain errors or misprints. The information it contains is regularly  
checked and corrections are included in subsequent editions. We disclaim any  
responsibility for any technical error or printing error, or their consequences.  
All trademarks and patents are recognized.  
Page | 4  
 

Lasko Fan S18300 User Manual
Learning Resources Watch LER 2288 User Manual
Lenoxx Electronics Air Conditioner AC13 User Manual
LG Electronics Computer Monitor 29UM65 P User Manual
LG Electronics Microwave Oven LMV1680DB User Manual
LG Electronics Refrigerator LRTN19310 User Manual
Lightolier Indoor Furnishings 1001FDL User Manual
Lincoln Electric Welder SVM188 A User Manual
Lyngdorf Audio Stereo Amplifier SDA 2175 User Manual
Midland Radio Marine Radio 77 092 User Manual