LST Smoke Alarm AMS 58000 700 User Manual

Optical-Thermal Detector

AMS-58000-700

• ADM loop technology with

Apollo/Discovery protocol

• Combination of optical and thermal

characteristics of ﬁre

• Alarm temperature 58°C

• Several sensitivity levels as well

as thermal-only and optical-only

operation selectable

• Constant response sensitivity

• Sealed electronics

Description

The addressable Optical-Thermal Detector AMS-

58000-700 uses the scattered light principle as well as

a separate thermal detection unit. It was developed to

detect the characteristics of ﬁre in a wide range of ap-

plications, and to avoid deceptive alarms. The modern

design of both measurement systems and the analysis

of the parameters by means of a deﬁned algorithm al-

low to reliably evaluate the characteristics of ﬁre.

tector. That ensures a periodical function testing of the

detector.

The inﬂuence of contamination of the optical measure-

ment system is compensated for by using intelligent

evaluation algorithms. With that, the response sensiti-

vity of the detector is kept constant for a long time –

a further effective step to avoid false alarms.

The response sensitivity and the operating mode of the

detector can be selected in 5 steps (optical-only ope-

ration, thermal-only operation as well as three multisen-

sor levels), via the ﬁre detection control panel.

The two LEDs with 360° visibility indicate the activa-

ted condition of the detector. The detector address

is selected by means of a code card in the detector

base. Therefore the detector can be changed without

additional tools.

The proven ADM loop technology with Apollo/Discove-

ry protocol establishes a permanent communication

between the ﬁre detection control panel and the de-

The detector can be attached to various bases and it

can be protected against theft.

Building Safety. Building Security.

AMS-58000-700_DBL_LST_EN_0804.PDF • PAGE 1