Kodak All in One Printer 1K5857 User Manual

Networking Setup Guide  
Guide de configuration réseau  
Guía de configuración de red  
Guia de configuração de rede  
All-in-One Printers • Imprimantes tout-en-un  
Impresoras multifunción • Impressoras Multifuncionais  
 
2
Setting Up the Wireless (Wi-Fi)  
Connection  
Before you connect  
You need to:  
• Have a functional 802.11 wireless network. Kodak recommends that you use a wireless access point,  
most commonly a router, that uses Dynamic Host Configuration Protocol (DHCP).  
• Determine whether your wireless router supports Wi-Fi Protected Setup (WPS).  
Temporarily disable your firewall until the printer is successfully installed and communicating.  
IMPORTANT: If you are unsure of how your network is configured, contact your Internet service provider or your  
network administrator for assistance.  
Using the LCD keyboard  
On the printer, press  
,
,
or  
to select the letters and numbers, using the correct uppercase and  
lowercase letters. Press OK after each character. When you are done, select DONE, then press OK.  
To erase a character, select BKSP (backspace), then press OK.  
To change from uppercase to lowercase, select abc/123, then press OK.  
To change from lowercase to uppercase, select ABC/123, then press OK.  
To enter punctuation or symbols, select !@#, then press OK.  
Connecting to a non-WPS wireless router  
To connect your printer to your wireless network, you need to know the network name, which is also called  
the Service Set Identifier (SSID). You can obtain your network name from the wireless router. See the  
manufacturer’s documentation for more information.  
If your network has security enabled, you also need to know the security string, which may be a Wired  
Equivalent Privacy (WEP) key or a Wi-Fi Protected Access (WPA/WPA2) passphrase.  
Record your network information in the spaces below, using the correct uppercase and lowercase letters.  
Network Name (SSID): __________________________________________________________________________  
Security String: _________________________________________________________________________________  
1. Press Home.  
2. Press  
to select Network Settings, then press OK.  
3. With WiFi Setup Wizard selected, press OK.  
NOTE: The Wi-Fi radio turns on automatically when you select WiFi Setup Wizard.  
The printer searches for available wireless networks within range, then displays the list in order of signal  
strength. If there are more networks than can be shown on the LCD, a  
(page down) symbol appears  
in the bottom right of the display. If you don’t see your network in the list, or if you want to change your  
network, select Rescan for Wireless Networks, then press OK.  
2
 
Setting Up the Wireless (Wi-Fi) Connection  
4. If the name of your network is:  
Listed  
Not Listed  
Press  
your network, then  
to select  
Make sure your wireless router is turned on and within range. If your  
wireless router does not broadcast its SSID:  
press OK.  
a. Press  
to select Unlisted network, then press OK.  
b. Use the LCD keyboard to enter your network name.  
c. Select WEP or WPA/WPA2 as required for your network's security  
setup, then press OK.  
5. If your network has security enabled, use the LCD keyboard to enter your security string.  
6. When the confirmation message appears, press OK.  
If the printer is successfully connected, the Wi-Fi status light should be on.  
If you are unable to connect your printer, go to www.kodak.com/go/inkjetnetworking.  
7. When the printer is successfully connected, install the KODAK All-in-One Printer Software on your  
computer. Follow the on-screen instructions to complete your setup.  
Connecting to a WPS wireless router  
1. Press Home.  
2. Press  
to select Network Settings, then press OK.  
3. With WiFi Setup Wizard selected, press OK.  
NOTE: The Wi-Fi radio turns on automatically when you select Wi-Fi Setup Wizard.  
4. With WPS Connect selected, press OK.  
5. Select one of these two methods of connecting:  
IMPORTANT: Before you press OK on the printer, make sure you know where the router's button is, or where to  
enter the generated PIN. If necessary, consult your Internet service provider or router  
manufacturer’s documentation for more information.  
Pressing a Button  
Entering a PIN  
a. With Push Button Configuration selected, press OK. a. Press  
to select Generate WPS  
PIN, then press OK.  
b. In your wireless router’s software,  
locate the PIN screen.  
b. Press or select the WPS button for your wireless  
router.  
NOTE: You will have two minutes to press or select the  
WPS button. It may be a button on the device  
or a virtual button in the device’s software.  
c. Enter the PIN you received from  
the LCD into the PIN screen.  
6. When the confirmation message appears, press OK.  
If the printer is successfully connected, the Wi-Fi status light should be on.  
If you are unable to connect your printer, go to www.kodak.com/go/inkjetnetworking.  
7. When the printer is successfully connected, install the KODAK All-in-One Printer Software on your  
computer. Follow the on-screen instructions to complete your setup.  
3
 
3
Setting Up the Ethernet Connection  
Before you connect  
You need to:  
• Have a functional Ethernet network that includes a router, switch, or hub with an Ethernet port.  
• Have a Category 5 (or higher) Ethernet cable.  
Temporarily disable your firewall until the printer is successfully installed and communicating.  
Connecting to an Ethernet network  
1. Connect the Ethernet cable into the Ethernet port on the back of the printer.  
2. Connect the other end of the Ethernet cable into an available Ethernet port on your router, switch,  
or hub.  
3. Install the KODAK All-in-One Printer Software on your computer. Follow the on-screen instructions to  
complete your setup.  
4
 
Eastman Kodak Company  
Rochester, NY 14650  
© Eastman Kodak Company, 2009  
Kodak is a trademark of Eastman Kodak Company.  
Specifications subject to change without notice.  
P/N 1K5857  
October 2009  
1K5857  
Printed in  
 

JBL Speaker GTO1204BP D User Manual
John Lewis Ventilation Hood JLBIHD105 User Manual
JVC Cassette Player KS F545 User Manual
JVC DVD VCR Combo HR XVC40B User Manual
JVC VCR HR J238E User Manual
Kettler Baby Accessories 08355 000 User Manual
Kidde Fire Extinguisher KITCHEN FIRE EXTINGUISHER User Manual
King Canada Sander CT 108C User Manual
Kompernass Clock Radio KH 2295 User Manual
Kramer Electronics Camcorder 104LN User Manual