Klipsch Portable Speaker CDT ARCHITECTURALCDT ARCHITECTURAL User Manual

CDT ARCHITECTURAL  
LOUDSPEAKER  
OWNER'S MANUAL  
 
WARRANTY—U.S. AND CANADA ONLY  
4. Insert the speaker assembly into the opening and attach by  
tightening the four Phillips screws (below). The frame’s four  
“dogs” will swivel out and “sandwich” the wall and frame togeth-  
er as they are tightened. If you use a power tool to tighten these  
screws, please use a low torque setting. Failure to do so could  
result in damage to your speaker.  
The Warranty below is valid only for sales to consumers in the  
United States or Canada.  
KLIPSCH, L.L.C. ("KLIPSCH") warrants this product to be free  
from defects in materials and workmanship (subject to the terms  
set forth below) for a period of five (5) years from the date of  
purchase. During the Warranty period, KLIPSCH will repair or  
replace (at KLIPSCH’s option) this product or any defective parts  
(excluding electronics and amplifiers). For products that have  
electronics or amplifiers, the Warranty on those parts is for a  
period of two (2) years from the date of purchase.  
To obtain Warranty service, please contact the KLIPSCH author-  
ized dealer from which you purchased this product. If your dealer  
is not equipped to perform the repair of your KLIPSCH product, it  
can be returned, freight paid, to KLIPSCH for repair. Please call  
KLIPSCH at 1-800-KLIPSCH for instructions. You will need to ship  
this product in either its original packaging or packaging afford-  
ing an equal degree of protection.  
5. Adjust the direction of the speaker by swiveling it to the  
left or right as needed. If desired, you may also adjust the tilt  
of the speaker and gently adjust the horn to the desired angle.  
Do not attempt to turn the tweeter stem while adjusting the  
swivel tweeter.  
Proof of purchase in the form of a bill of sale or receipted  
invoice, which is evidence that this product is within the Warranty  
period, must be presented or included to obtain Warranty service.  
This Warranty is invalid if (a) the factory-applied serial number  
has been altered or removed from this product or (b) this product  
was not purchased from a KLIPSCH authorized dealer. You may  
call 1-800-KLIPSCH to confirm that you have an unaltered serial  
number and/or you purchased from a KLIPSCH authorized dealer.  
This Warranty is only valid for the original purchaser and will  
automatically terminate prior to expiration (if applicable) if this  
product is sold or otherwise transferred to another party.  
This Warranty does not cover cosmetic damage or damage due  
to misuse, abuse, negligence, acts of God, accident, commercial  
use or modification of, or to any part of, the product. This  
Warranty does not cover damage due to improper operation,  
maintenance or installation, or attempted repair by anyone other  
than KLIPSCH or a KLIPSCH dealer which is authorized to do  
KLIPSCH warranty work. Any unauthorized repairs will void this  
Warranty. This Warranty does not cover product sold AS IS or  
WITH ALL FAULTS.  
6. At this point, you may paint the speaker grilles before attach-  
ing them to the speaker. Klipsch grilles are designed to accept  
most types of paint. Care should be taken to avoid excessive  
paint build-up in the grille perforations.  
7. Press the grille into place.  
See back page for more illustrations.  
OPERATING CONTROLS  
Mid-Bass and Tweeter Attenuator Switch  
(3000 and 5000 Series)  
REPAIRS OR REPLACEMENTS AS PROVIDED UNDER THIS  
WARRANTY ARE THE EXCLUSIVE REMEDY OF THE CONSUMER.  
KLIPSCH SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR  
CONSEQUENTIAL DAMAGES FOR BREACH OF ANY EXPRESS OR  
IMPLIED WARRANTY ON THIS PRODUCT. EXCEPT TO THE  
EXTENT PROHIBITED BY LAW, THIS WARRANTY IS EXCLUSIVE  
AND IN LIEU OF ALL OTHER EXPRESS AND IMPLIED  
WARRANTIES WHATSOEVER, INCLUDING BUT NOT LIMITED TO,  
THE WARRANTY OF MERCHANTABILITY AND FITNESS FOR A  
PRACTICAL PURPOSE.  
Some CDT models feature a Tweeter switch (3000 series) or  
both a Mid-Bass and a Tweeter switch (3000 & 5000 series)  
located on the front baffle. The switch allows a setting of either  
0dB (normal) or –3dB in the respective frequency range. If  
installing in an acoustically bright room, such as a bathroom or  
kitchen, you may want to adjust the Tweeter level switch. If the  
speaker is located in a corner and produces too much bass, you  
may need to adjust the Mid-Bass level switch. The position  
of the switches should always be checked prior to attaching  
the grille.  
 
ARCHITECTURAL SPEAKERS  
Some states do not allow the exclusion or limitation of incidental  
or consequential damages or implied warranties so the above  
exclusions may not apply to you. This Warranty gives you specific  
legal rights, and you may have other rights, which vary from  
state to state.  
WARRANTY OUTSIDE THE UNITED STATES AND CANADA  
The Warranty on this product if it is sold to a consumer outside  
of the United States or Canada shall comply with applicable law  
and shall be the sole responsibility of the distributor that sup-  
plied this product. To obtain any applicable warranty service,  
please contact the dealer from which you purchased this prod-  
uct, or the distributor that supplied this product.  
 
3502 Woodview Trace, Suite 200  
Indianapolis, Indiana 46268  
.
.
1 800 KLIPSCH  
 

John Deere Lawn Mower Accessory 48C User Manual
JVC Camcorder GR AX940 User Manual
Kambrook Food Warmer KHP1 User Manual
Kenwood Car Amplifier KAC PS501F User Manual
Kenwood Stereo Receiver VR 5900 User Manual
Keys Fitness Treadmill HT402t User Manual
Kicker Car Amplifier DXA10001 User Manual
King Canada Sander KC 26DS User Manual
KitchenAid Gas Grill KBGN274PSS User Manual
Kompernass Sprinkler KH 4083 User Manual