Kambrook Vacuum Cleaner KBV40 User Manual

Kambrook 461 Plummer Street, Port Melbourne 3207, Australia  
Customer Service Line (free call) 1800 800 634 Customer Service Fax 1800 621 337  
Kambrook New Zealand, Private Bag 94411, Greenmount, Auckland, New Zealand  
Customer Service Line/Spare Parts 09 271 3980 Customer Service Fax 0800 288 513  
Jaguar Bagless  
Vacuum Cleaner  
Due to continual improvement in design or otherwise, the product you purchase may differ slightly from the one illustrated in this book. Issue 1/06  
 
KBV40  
Issue 1/06  
To retract the cord push down on the  
‘cord rewind’ pedal.  
canister fills up.When the dust canister  
indicator displays ‘red’ it is time to empty  
the canister. Otherwise you can look  
at the canister at the back end of the unit  
and decide when you would like to empty  
it.  
4.To remove the HEPA filter rotate the  
filter in an anti-clockwise position until  
released.Then lift the HEPA filter  
vertically to remove.  
UsingYour Kambrook Jaguar  
Vacuum Cleaner  
Remove all packaging from the unit, hose  
and other accessories; ensure that you  
have removed all of the accessories before  
discarding the packaging.  
IMPORTANT: HOLD THE PLUG END  
WHEN RETRACTING THE CORD TO  
PREVENT IT FROM STRIKINGYOU OR  
THEVACUUM.  
5.Tap and shake the filter until all the fine  
dust particles are removed. However  
after approximately 6 months the filter  
should be replaced.  
Always switch appliance off, then switch  
off at the power outlet and unplug the  
appliance prior to replacing filters or  
emptying the dust canister.  
ALWAYS ENSURETHATTHE  
DUST CANISTER ANDTHE  
MOTOR PROTECTION FILTER ARE  
CORRECTLY FITTED. NEVER  
OPERATE WITHOUTTHE DUST  
CANISTER AND FILTERS IN PLACE.  
Ensure that the dust canister and filters  
are correctly fitted.  
6.To place the filter back in the dust  
canister simply place the HEPA filter in  
the dust canister lid and turn the filter  
in a clockwise direction to lock it  
in place.  
Locate the crush proof hose and push the  
connection point into the hose inlet  
connection on the front of the unit, until a  
“click” sound is heard.  
To remove the dust canister, ensure the  
unit is down on its wheels; Remove the  
dust canister by clasping the handle and  
pressing down on the button above the  
dust canister. Once released slowly pull  
the canister toward you.  
Variable Power Control  
Connect the wide end of the metal wand  
to the hose end, and push together firmly.  
The On/off button, on the top of the unit,  
is also to be used for variable power  
control. Turn the control clockwise for  
maximum power for vacuuming hard floor  
and carpet surfaces.Turn the control anti-  
7.To place the mesh filter bracket back in  
place, ensure that it is completely dry  
before use. Simply place the filter on  
top of the HEPA filter and ensure the  
indents in the mesh filter holder meet  
with the grooves in the dust canister  
lid.This will ensure that the mesh filter  
bracket is locked in place.  
Fit the floor tool to the narrow end of  
the wand/s and push together firmly.  
To empty the dust canister simply place it  
above the rubbish bin; lift the “lift and  
press” lever and then press the button.  
The bottom of the canister will release  
and the dust and compiled dirt will be  
dispensed.  
Fully extend the power cord by pulling  
the power plug (situated at the rear of the clockwise for minimum power when using  
unit) out from the unit, until the yellow  
tape on the cord is shown.  
the crevice and brush tools.  
Crevice and brush tool accessories  
The crevice tool is ideal for vacuuming  
hard to reach places such as the edges  
along skirting boards.  
ENSURETHATYOU DO NOT  
8. Place the complete filter assembly back  
on top of the dust canister. Place the  
dust canister back in the vacuum  
cleaner for next use.  
OVER EXTENDTHE POWER CORD  
– DO NOT EXTEND PASTTHE RED  
WARNINGTAPE ONTHE CORD  
IMPORTANT: DO NOT USE THE  
UNIT WITHOUT A DUST CANISTER  
IN PLACE  
The brush tools can be used to vacuum  
delicate surfaces and areas such as shelves  
and venetian blinds.  
Plug into a 230/240v power point and  
switch the power on.  
Cleaning and replacing filters  
Filters must be cleaned from time to time  
Motor protection filter  
The motor protection filter must always  
to remove the fine dust particles that have be in place when operating the vacuum  
To commence vacuuming push down on  
the on/off foot pedal, at the top, rear of  
the unit.  
Set the variable speed control between  
minimum and medium power when using  
the tool accessories.  
been collected.  
otherwise damage to the motor may occur.  
1. Remove the dust canister from the unit  
2. Lift the lid of the dust canister  
To replace the motor protection filter –  
remove the dust canister.The motor  
protection filter is located at the rear of  
the inner chamber. Pull the plastic filter  
holder toward you to remove. Replace  
the filter and push the holder back in  
place once filter replacement been made.  
When vacuuming is complete, push down  
on the ‘on/off’ pedal to switch off.  
Turn the power off at the outlet and then  
remove the power cord from the power  
outlet (when removing plug from the  
power outlet grasp the plug not the cord).  
Turn off the vacuum cleaner when  
changing any attachments.  
3.Take off the mesh filter by lifting it  
vertically; this filter can be washed in  
luke warm water. Ensure you let the  
filter completely dry naturally before  
next use.  
Dust canister indicator and  
dispensing the dust canister  
The dust canister should be emptied  
when full.The dust canister indicator  
window will gradually turn red as the  
4
5
 
KAMBROOK  
2YEAR REPAIR  
WARRANTY  
Fresh Air Boost control  
Within the air filter covers on both sides  
of the unit, there are scent canisters.To  
remove the canister, simply press down on  
the top end of the canister and pull it  
away from the filter cover. Lift the lid of  
the canister and place three scent balls in  
the canister and close it.To place the  
canister back in the filter cover, simply  
position the bottom end of the canister in  
the indented area and push on the top of  
the lid of the canister and then release.  
The canister will be secured within the  
filter cover. Repeat the process for the  
other side of the vacuum cleaner.  
KAMBROOK warrants the purchaser  
against defects in workmanship and material, accessories only the defective accessory  
for a period of 2 years from the date  
of purchase (3 months commercial use).  
If the product includes one or a number of  
or product will be replaced.  
Note: Cleaning of building and industrial  
material will not be covered by warranty.  
Guarantee and purchase receipt for this  
product are to be retained as proof  
of purchase and must be presented  
if making a claim under the terms of the  
KAMBROOK guarantee.  
In Australia, this KAMBROOK Guarantee  
is additional to the conditions and  
guarantees which are mandatory as  
implied by the Trade Practices Act 1974  
and State Territory legislation.  
KAMBROOK reserves the right to repair  
the appliance within the warranty period.  
For service, spare parts or product  
information in Australia, please call  
KAMBROOK on the customer Service  
Line (free call) 1800 800 634.  
Warranty does not apply to any defect,  
deterioration, loss or injury or damage  
occasioned by, or as a result of the misuse  
or abuse, negligent handling or if the product  
has not been used in accordance with the  
instructions. Items subject to wear and  
tear, such as filters, bags, accessories and  
drive belts, are not covered by this  
warranty.The guarantee excludes  
When you turn the vacuum cleaner on  
and commence vacuuming a Fresh scent  
will be released in the air.Three scent  
balls in each canister will last  
approximately six months.A bag of scent  
ball is enclosed for your perusal.  
For service, spare parts or product  
information in New Zealand,  
please call KAMBROOK New Zealand,  
Greenmount, Auckland Phone 09 271 3980  
Fax 0800 288 513. For spare parts phone  
09 271 3980.  
Care and Maintenance  
Always switch appliance off, then switch  
off at the power outlet and then unplug  
the appliance prior cleaning or replacing  
either filter.  
breakages and consumables.  
If claiming under this guarantee the product  
must be returned to freight prepaid.  
This warranty is void if there is evidence  
of the product being tampered with by  
unauthorised persons.  
To clean the outside of the unit, wipe the  
exterior with a soft, damp cloth. Never  
use an abrasive cleaner.  
YOUR PURCHASE RECORD (Please complete)  
Attach a copy of  
purchase receipt here.  
Check and replace both the motor  
protection and dust filters on a regular  
basis.  
DATE OF PURCHASE___________________________
MODEL NUMBER _____________________________
SERIAL NUMBER (If applicable) ___________________
Please don’t return purchase record  
unless you are making a claim  
PURCHASED FROM ___________________________
6
 

InFocus Cordless Drill DV 14DL User Manual
Jenn Air Kitchen Grill SVD48600 User Manual
JVC CD Player XL PG39BK User Manual
JVC Security Camera VN H217U User Manual
Keating Of Chicago Fryer 14 BB User Manual
Kenmore Dishwasher 6651312 User Manual
Kenwood Car Stereo System EZ500 User Manual
Kenwood Car Video System KVT 627DVD User Manual
Keys Fitness Home Gym KPS 1850 User Manual
Kompernass Carpet Cleaner KH 2424 User Manual