130X93MM
KA2031
KA2031 is manufactured for
Electronics,Inc(USA) by Kaito EnterprisesCorp. In China
PLL Digital Radio
With AM/FM/TV/NOAAWeather Bands
5
Never get the radioto a chemical thatmight damage the caseof the radio.
Buttons and Names
SPECIFICATIONS
Power Source 3 AA size batteries(DC 4.5V)
FrequencyRange
AM 520- 1710 KHz
F M 8 8 - 1 0 8 M H z
24
23
TV CH2-CH13 MHz
WB CH1-C H7 MHZ
C H A N N E L FREQUENCY
1
2
3
4
5
6
7
162.550 MHz
162.400 MHz
162.475 MHz
162.425 MHz
162.450 MHz
162.500 MHz
162.525 MHz
22
SNOOZE
21
20
1/ALL1 SET
2/ALL12 SET
10
AM/FM ST/TV/WB/NOAA PLL SYNTHESIZED STEREO WORLD RECEIVER
11
1
BAND/ALERT
ENTER
19
25
2
18
17 16 15 14
1
Speaker 8Ohms 1 W
Power Output 200 mW
Output Jack Earphone 32 Ohm
Disclaimer:
1. Telescopic Antenna
2. Back Light Button
3. LCD
4. Stand (On the back side)
5. Power Button
6. Carrying Strap Holder
7. STAND BY/SLEEP
8. Tuning UP/MIN Set
9. Volume Control Knob
10.Tuning DN./HOUR set
11. Lock Switch
14. Enter Button
15. BAND Selector
16. Mode Button
17. TIME SET/MEMORY
18. Reset (Inside battery compartment)
19.Battery Compartment
20.DC Jack
21.Earphone Jack
22.DX/Local Switch
23. Extend Antenna Jack
24.Volume Indicator
25. 1/AL Set ( Alarm Set 1)
26. 2/AL Set ( Alarm Set 2)
Due to the signal strength changes in different areasin the country, the
radio is not guaranteed to receive the NOAA alert signals, Kaito
Electronics Inc. is not responsible for any damage or loss due to the
NOAA signal is not received.
For any further information, please visit our website www.kaitousa.com
Or contact us at toll free number 1-866 524 8676, 909 628 6088
Kaito Electronics,Inc
12.Preset 0......9
13. Snooze Button
5185 Cliffwood Drive, Montclair CA 91763 USA
1
6
TWO TURN-ON TIMERS
The radio canbe turned onat two differenttime.
1.When the radiois turned off,press 1/AL1 SETbutton twice, the" " willbe
shown on theLCD display,then press TIMESET MEMORYbutton twice, the"
AL1 " willbe shown andyou can pressHOUR/TUNE- and MIN/TUNE+
seperately to adjustthe time. After the timeflash several times, the radio wil
display " "and clock. Theradio will beturned on atthe preset time.
Press1/AL1 SET button,the function iscancelled.
POWER SOURCE
2.When the radiois turned off,press 2/AL2 SETbutton twice, twice the " "will
be shown onthe display,then press TIMESET MEMORYbutton three times, the
"AL2" will beshown and youcan press HOUR/TUNE-and MIN/TUNE+
seperately to adjustthe time. After the timeflash several times,theradio wil
display " "and clock. Theradio will beturned on atthe preset time. Press
2/AL2 SET button,the function iscancelled.
BATTERY OPERATION
1. Open the battery compartment cover.
2. Insert 3 AA size batteries into the compartment, make sure the polarity
is correct as shown on the diagram("+" and "-")
TO PREVENT POSSIBLEDAMAGE TO THERADIO
Note: Make sure you select AM/PM Properly.
1.Load the batteries with correct polarity.
2.If the radio is not used for a long time, remove all the batteries out
and put it in a safe place. Avoidextreme hot or cold.
3.Remove the low batteries as soon as the sound volume gets low or
hard to receive stations.
ANTENNAS
FM/TV/WB
Pull out thetelescopic antenna andadjust its lengthand angle foroptimum
reception.
4.Do not mix the new and low batteries when you put the batteries in.
FM/TV/WB
AM
TO USE THEAC ADAPTOR(Optional)
The built inferrite antenna willgive you agood reception onAM, butyou need
to adjust thedirection to getthe max receptionon theAM station.
If you try use the AC adaptor, make sure the voltage and output polarity
is correct as specified in the radio.
AM
RADIO OPERATION
RADIO MAINTENANCE
1.Set LOCK switch to OFF.
2.Press POWER button to turn on the radio.
3.Adjust the volume to a proper level.
4.Use BAND/ALERT (Band Selector15) to change bands between
AM/FM/TV/WB.
5.Press the Light button, the backlight will last for 8 seconds.
6.To tune the radio, you can key in or step search for the AM/FM
stations; for TVand Weather bands. On AM/FM bands, you can use the
tuning button or numbers to direct key in the frequency; in TV/WBband,
just press the tunning button to select the channels.
1.If the radio isnot used for along time, remove thebatteries from the battery
compartment to prevent possiblebattery leakage.
2.The radio should bekept in a placewith no extreme heator cold. Do notget
the radio in avery humidity place andnever get any liquidinto the radio.
3.Takethe radio with care,any shock may damagethe parts inside.
4.When use the radioin a moving vehicle, a cement building, use the radio
close to the openwindow for better reception.Any metal willhave interference
on the reception.
2
5
1. SETTING CLOCK MODE
When the radiois off, thecurrent time displayson the LCD. When the
radio is on, press MODE button, it switches amongthe modes: time,
alert1, alert2, frequencyand time repeatedly. If itis set totime mode, 4
seconds later, it will goback to frequencymode automatically.
2. ADJUSTING THE CLOCK
When the radiois OFF, press TIMESET button, theclock number will
flash, then usethe HOUR/TUNE+ buttonto adjust Hour, and
MIN/TUNE- button toadjust minute. After a fewseconds, the timeis
set automatically.
SLEEP TIMER
1. When the radio is turned on, press the SLEEP button, then
90 and " SLEEP " will appear on LCD. You can select the desired time
from 10 to 90 by pressing the SLEEP button, and the radio will turn off
automatically at the preset time. If the knob is pressed again, the sleep
function is cancelled.
TO SET THE ALARM TIME
YOU CAN SET TWO ALARM TIME
1. Turn off the radio;
2. Press 1/AL1 SET button, " 1 " will appear on the display. Then press
TIME SET MEMORY button twice, " Al1 " will appear on the display. The alarm
time will flashon the LCD, meanwhile press HOUR/TUNE- or MIN/TUNE+
button seperately as many times as needed till the required time is reached.
After the time flash several times,the radio is set with the alert 1. Then press the
POWER button to turn on the radio and listen to the radio.
Tocancel the alert time, press the 1/AL1 button again, the alert is cancelled.
Toselect second alert, use the button 2/AL2 Set button as the step stipulated
above.
3.When you hear the unit alarm, press SNOOZE button, the radio will stop
alarm, but 8 seconds later, the radio will alarm again.
Note: You have to choose AM/PM Properly.
4
|