SPEAKER UNIT
INSTALLATIONANLEITUNG :LAUTSPRECHEREINHEIT
MANUEL D’INSTALLATION :ENCEINTE
MANUALE D’INSTALLAZIONE :UNITÀ DI DIFFUSIONE
MANUAL DE INSTALACION
:UNIDAD DE ALTAVOZ
:
INSTALLATION MANUAL
TS-C500SPG
SPEAKER UNIT FOR A JVC PLASMA DISPLAY MONITOR
LAUTSPRECHEREINHEIT FÜR JVC PLASMA BILDSCHIRM
ENCEINTE POUR UN MONITEUR DE VISUALISATION PLASMA
UNITÀ DI DIFFUSIONE PER MONITOR CON SCHERMO AL PLASMA JVC
UNIDAD DE ALTAVOZ PARA MONITOR PLASMA DISPLAY JVC
LCT1635-001A
Attaching the front speakers to the GM-X50 series display
Using the speaker brackets, you can attach the front speakers to the side of the display.
• Do not loosen the screws other than the protective screws.
• Use only the supplied mounting screws for attaching the front speakers.
1. Remove the protective screws on the back of the display
with phillips screwdriver.
Protective
screw
Protective
screw
2. Attach the front speaker to the back of the display.
1 Turn the mounting screws with phillips
2 Hook the speaker bracket onto three mounting screws
screwdriver, leaving a length of about 3 mm.
through the screw holes (A), and slide it down.
Screw hole (A)
3. Tighten the mounting screws firmly with phillips screwdriver.
• When moving the display, do not hold the speakers.
• The speakers are not of anti-magnetic type.
Do not place anything susceptible to magnetism, such as a video tape, nearby when setting the speakers.
2
Connecting the speaker cord
Attach to the speakers
When you connect the supplied speaker cord to the terminal clamp of the speakers, fold the end of each speaker
cord to avoid short-circuit.
1. Fold the end of each speaker
cord.
2. Press and hold the terminal
clamp.
3. Insert the speaker cord, and
release the finger from the
terminal clamp.
• Connect the cord with black stripes to the · (black) terminal and the other cord to the ª (red) terminal.
• Be careful that connection of the speaker cords to incorrect polarity terminals (ª and ·) degrades stereo
feeling and sound qualities.
Attach to the display
1. Open the terminal clamp.
2. Insert the speaker cord.
3. Close the terminal clamp.
• Connect the cord with black stripes to the · (black) terminal and the other cord to the ª (red) terminal.
• Be careful that connection of the speaker cords to incorrect polarity terminals (ª and ·) degrades stereo
feeling and sound qualities.
• Attach the ferrite core supplied with your display to the speaker cord.
For details, refer to the instruction manual of your display.
Bundling the speaker cords
You can bundle the speaker cords neatly with the supplied cord clamp, as illustrated.
Cord clamp
• Stick the cord clamp firmly after removing its protective seal.
• When sticking the cord clamp on the display:
— Make sure not to block the ventilation hole.
— Make sure not to prevent attachment of the options, such as a Wall Mounting Unit or
a Ceiling Suspension Unit.
Speaker cord
3
Specifications
• Power Handling Capacity : 3 W
• Impedance
• Speaker
: 6 Ω
: 9.5 cm x 1 cm
Direct Drive Speaker, two
• Dimensions
(W x H x D)
(Mass)
: 42 mm x 740.5 mm x 54 mm
: 0.9 kg (for each excluding the speaker bracket)
Top view
Front view
Side view
Unit: mm
4
VICTOR COMPANY OF JAPAN, LIMITED
© 2004 VICTOR COMPANY OF JAPAN, LIMITED
0204MKH-MW
|